FDP Forum / pick guard (SORRY)/ 3 messages in thread.

1 to 3 of 3 shown.


fender213



USA

Marcus Swicegood
Dec 23rd, 2017 05:14 PM        

My bad left out the meat of the question!!Had a brain fart. Can the 1 ply pick guard "which comes standard" be replaced w/ a 3 ply pick guard, or will there be some height issues here, if the 3 ply is not standard on the Fender Squire Affinity series Strat



daveg

Contributing Member
**********

Northern VA

The Fine Line Between Clever & Stupid
Dec 23rd, 2017 05:51 PM        

It's not a problem. I replace the 1 ply that came of my 57AVRI with a 3-ply. No issues.



Peegoo

Contributing Member
**********
**********
******

Curled up

in the fecal position
Dec 23rd, 2017 09:08 PM        

Yeah--thickness is not a problem. <br /> <br /> Be advised, though, you may need to drill a few new holes in the body because not all pickguards are created equal. Even a real-deal Fender replacement 'guard might need to be fitted to the body because the mounting screw locations in the original and replacement 'guards may be slightly off.<br /> <br /> If any screw hole in more than about 1/64" off, you'll need to plug the existing hole in the body and re-drill. Forcing a pickguard to fit always results in the plastic buckling in the direction you're forcing it.



Copyright 1999-2003 Fender Discussion Page, LLC. Visit the web site at http://www.fenderforum.com