FDP Home Page / FDP Forum / FAQ's

The FDP is made possible by the following companies and individual members like you.
Please use the links below to show them we value their sponsorship.

Amazon

Yellowjackets Tube Converters

Apex Tube Matching

Sweetwater

WD Music

Jensen Loudspeakers

Musician's Friend

Guitar Center

Amplified Parts

MOD KITS DIY

Antique Electronics Supply


* God bless America and our men and women in uniform *

* Illegitimi non carborundum! *

If you benefit and learn from the FDP and enjoy our site, please help support us and become a Contributing Member or make a Donation today! The FDP counts on YOU to help keep the site going with an annual contribution. It's quick and easy with PayPal. Please do it TODAY!

Chris Greene, Host & Founder

LOST YOUR PASSWORD?

......................................................................

   
FDP Jam
Calendar
Find musicians
in your area!
  Search the Forums  

FDP Forum / The 'Pup' Tent / What makes a SC pup howl (in a bad way)?

Bigfoot
Contributing Member
****

Indy

The floor is getting farther away...
Mar 16th, 2016 09:05 PM   Edit   Profile   Print Topic   Search Topic

I had to replace the neck pup on my Strat years ago and it normally is a good match with the other 2 pups. But the other day I got real close to my amp and is squealed horribly with the neck pup engaged. So I switched to the other pups in the same proximity to the amp and the other 2 did not squeal. What causes that?

Te 52

Laws of Physics

strictly enforced
Mar 17th, 2016 10:01 AM   Edit   Profile   Print Topic   Search Topic

It's positive feedback, just like you get when a microphone is too close to a speaker. The two most common causes are (A) general flexibility of the pickguard and pickup mounting or, (B) pickup has gone microphonic.

In case (A), the sound waves from the speaker hit the pickguard and pickup, causing them to oscillate, which in turn creates more signal since the pickup is moving relative to the string, the signal goes through the amp and speaker, etc., etc.

Make sure your pickguard screws are all there and are snug. Check that there's some tension on the pickup height springs, or, if they're rubber, that they haven't gotten stiff and dried out. As a last resort, put a piece of foam rubber under the pickup, sandwiched between it and the bottom of the cavity.

In case (B), the pickup coil turns have gotten loose and are moving. Solution is either to wax-pot the pickup, get it re-wound, or replace it.

(This message was last edited by Te 52 at 03:17 PM, Mar 17th, 2016)

Peegoo
Contributing Member
**********
**********
******

Eat. Sleep. Guitar.

Repeat
Apr 22nd, 2016 03:58 PM   Edit   Profile   Print Topic   Search Topic

The pickup coil can also be wrapped carefully with thread (it takes about an entire spool) to hold unpotted coil wires in place.

FDP Forum / The 'Pup' Tent / What makes a SC pup howl (in a bad way)?




Reply to this Topic
Display my email address             Lost your password?
Your Message:
Link Address (URL):
Link Title:




Moderators: Chris Greene  Iron Man  reverendrob  

FDP, LLC Privacy Policy: Your real name, username, and email
are held in confidence and not disclosed to any third parties, sold, or
used for anything other than FDP Forum registration unless you specifically authorize disclosure.

Furtkamp.com 
Internet Application Development

Copyright © 1999-2017 Fender Discussion Page, LLC   All Rights Reserved